Weber Jaguar 3.8/4.2 3 x Weber 45 DCOE Carburettor Kit

Description

3.8/4.2 3 x Weber 45DCOE

Webcon triple DCOE kit for 3.8/4.2 engine as fitted to Jaguar E Type

Comprises

1 x British made intake manifold

3 x Genuine Spanish Weber 45DCOE 152G carburettors (4 progression hole)

1 x Webcon rod linkage set
Studs, nuts washers and mountings.

 

Manifold threaded connections are as follows:

 

Top water temp sender 5/8 UNF

Coolant rear 3/8 BSB

Servo rear 1/2 BSP

The carburettors are superbly jetted to offer a truly Turnkey package on stock motors delivering great power, torque without excessive fuel consumption. The use of 4 progression holes ensures that the transition from idle is smooth and flat spot free

This calibration works well on road cars. For higher states of tune, it is recommended that the carburettors be set up on a rolling road.

Filters are not supplied, but we recommend the use of our Mesh filters AFM4563 seen here

Please note that if this kit is fitted in anything other than a S3 4.2 E type, it is likely that the OEM thermostat housing will not fit the new manifold and in that case, a replacement thermostat housing will be needed.

We have this available as part number 9990320300 in the Related Products tab

The length of the manifold and carburettor assembly is 235mm excluding airhorns. The stock airhorns supplied with the kit are 62mm giving an overall length of 297mm

If this is too long for your application, we have airhorns available as follows:

Air Horn                  Overall length
16mm                        251mm
26mm                        261mm
39mm                        274mm
55mm                        290mm

If you would like the airhorns changed, please note this in the comments section of the order.

Please note that, owing to our policy of continuous improvement, kit contents may be subject to change without prior notice.

PJA301C